ILCE-5100 Camera Firmware Update (Windows)

This update only applies for ILCE-5100 cameras.

If your camera firmware version is already version 3.10, this update is not necessary.

Check the version of your camera firmware:

1. Power on the camera.
2. Press the Menu button.
3. At the Menu screen, use the Control Wheel to select Setup, and then press the center button of the Control Wheel.
4. At the Setup screen, use the Control Wheel to scroll to Version, and then press the center button of the Control Wheel.
5. The firmware version is displayed on the LCD screen.
   

6. Note: If the current firmware version is 3.10 or higher, the camera does not need this update.

7. Press the center button of the Control Wheel to close the version number display.

• WARNING: This utility is only for use with the Sony® ILCE-5100 camera. Do not install this utility with any other model.
• WARNING: This Digital Camera firmware update and any changes incurred by it are permanent. It is not possible to return to a previous firmware version after updating this firmware. By continuing this update process and downloading and updating this firmware, you acknowledge that you are aware and understand that this update cannot be reversed.
• IMPORTANT: Do not allow the computer to enter Sleep (Standby) mode during the update process. To change your settings, please refer to your computer manual or consult the manufacturer.
• This update process requires the following items for proper updating:
  • A computer with:
    • Available Hard Disk Space: 200 MB or more
    • Installed Memory (RAM): 512 MB or more
    • A USB port.
    • One of the following Microsoft® Windows® operating systems installed:
      • Windows 10
      • Windows 8, 8.1
      • Windows 7 (with Service Pack 1)
      • Windows Vista® (with Service Pack 2)

      • Note: Starter Edition of Windows Vista is not supported.

  • Camera power supply:
    • When performing the firmware update, use a fully charged NP-FW50 rechargeable battery pack, or the AC-PW20 AC adapter/charger (sold separately).

    • WARNING: The camera may not operate properly if the power is interrupted during the update.

  • USB cable:
    • Use only the USB cable supplied with the camera.

    • IMPORTANT: Update functionality is not guaranteed with any other USB cable.

• To ensure that no other program interferes with the installation, save all work and close all other programs. The Taskbar should be clear of applications before proceeding.
• It is highly recommended that you print out these instructions for use as a reference during the installation process.

1. Remove the memory card from the camera
2. Power on the camera.
3. Press the Menu button.
4. At the Menu screen, use the Control Wheel to select Setup, and then press the center button of the Control Wheel.
5. At the Setup screen, use the Control Wheel to scroll to USB Connection and verify that Mass Storage is selected.